Monitoring these sometimes very low concentration levels is a responsible task. Measures the lowest-quantity concentrations with lab-quality analysisĬoncentrations of hazardous substances in ambient workplace air must never exceed the defined limits. All calibration information on the RFID.Based on colorimetric chemical sensor technology.Precise gas measurement in the lower ppb range.The multi gas meter is extremely easy to use: insert the Dräger MicroTubes, start measuring, then read out the test result. This replaces slow, expensive lab analyses. The Draeger multi gas detection monitor also gives hazmat responders precise results right on site. This gas detection device lets hazmat responders precisely measure gases in the low ppb range. This innovative Draeger gas detection system consists of Draeger MicroTubes and an opto-electronic analysis device. 1, groups F, G 5 ° C ≤ Ta ≤ + 40 ° C Temp.This is the Draeger X-act 7000 Multi-Gas Detector Pump. Certifications: - ATEX Ex ia IIC T4 Ga Ex ia I Ma I M1 / II 1G - MED in accordance with Directive 96/98 / EC relating to marine equipment - cUL Class I, div.Power systems - Rechargeable NiMH battery, T4 7.2 V 1,500 mAh - Charging time 1,000 pump strokes - Sampling: up to 12 hours, depending on the defined flow.Ambient conditions - Operating temperature from 5 to 40 ° C - Humidity 0 to 95% RH, non-condensing - Pressure from 700 to 1,300 hPa.Sampling: - Adjustable sampling time, up to 12 hours, depending on the defined flow - Resolution in 15-minute steps (default setting) or in 1-minute steps.Number of pump strokes: Volume per adjustable stroke, from 1 to 199 100 ml.Use: Spot measurements with Dräger test tubes.Technical data of the Dräger X-act 5000 pump Can be used in potentially explosive areas (ATEX Gas).Possibility of connecting a sampling hose up to 30 meters.Ideal for measurements requiring a large number of pump strokes.Main advantages of the X-act 5000 automatic pump For remote sampling such as wells, manholes, it is possible to connect a sampling pipe with a maximum length of 30 meters. The intrinsically safe Dräger X-act 5000 pump can be used for applications in confined spaces and in classified areas (ATEX Gas). The defined data, elapsed time and sample volume are displayed on the screen. It then stops automatically at the end of the measurement. Once the sampling time has been configured, the pump can be started immediately. This procedure for carrying out measurements has the advantage of being simplified and the error risk of is minimized.ĭepending on the tubes or sampling devices, it is possible to directly adjust test parameters, without using a flow meter. To automatically transfer and display the data concerning the name of the to be measured substance, the number of pump strokes and the measuring range, simply pass the barcode in front of the pump reader. The barcode printed on the label affixed to the back of the Dräger reagent tube boxes contains all the necessary measurement parameters. One of the key principles of the X-act 5000 automatic pump is the ability to provide the flow characteristics necessary to the measurement.

Xact air pump